Wooden Handle for Ultegra 14000 XTD / XTE Type Handle


Exotic hardwood handle conversion for Shimano Ultegra 14000 XTD XSD, Ultegra Ci4 14000/5500 XTB XSC, Power Aero XTB XSB etc.

Please choose from the list of products for the Shimano Ultegra 14000 XTE (2022).

Supplied with Black anodised spigot.

Fitting Instructions

Swapping the original moulded plastic knob fitted as standard could not be simpler, which can be done in the comfort of your own living room using a small Philips screwdriver & pick tool.

Simply remove the chrome cover from the standard knob by placing a pick tool or small flat screwdriver under one end and gently lifting. Once removed, this will reveal a small Philips screw, undo the screw and slide off the original moulded knob. Then, using the screwdriver, gently tease both factory bearings or bushes (depending on the model) from the original knob along with the shim washers. Fit one bearing or bush into the end of the new Black spigot, which will face the reel arm and slide back onto the reel arm shaft. Then fit the washers, followed by the second bearing/bush, onto the shaft and into the spigot and tighten the screw. Finally, once the spigot is mounted to the shaft, screw the alloy knob on turning clockwise and nip up by hand.

Our replacement wooden knobs are manufactured from exotic hard wood and measure 42mm x 18mm. They will not take on water and swell up or splinter!

SKU: N/A Category:


Suitable for:

  • Ultegra 14000 XTD
  • Ultegra 14000 XTE