Daiwa Carbon Handle Knob & Spigot (Suits Various)

Carbon knob and spigot conversion for Daiwa 35/45 SCW QD,Basia 45 SCW,Emblem Spod SCW QD, 18 Ninja LT, and similar. Please check your handle knob unscrews before ordering.

Supplied with coloured anodised spigot select option from list.

Fitting Instructions

Swapping the original moulded plastic knob fitted as standard could not be simpler and can be done in the comfort of your own living room using a small Philips screwdriver & pick tool.

• Simply remove the chrome cover from the standard knob by placing a pick tool or small flat screwdriver under one end and gently lifting.
• Once removed, this will reveal a small Philips screw. Undo the screw and slide off the original moulded knob.
• Using the screwdriver, gently tease both factory bearings or bushes (depending on the model) from the original knob along with the shim washers.
• Fit one bearing or bush into the end of the new spigot, which will face the reel arm, and slide back onto the reel arm shaft.
• Then fit the washers (note washers may not be required on assembly) followed by the second bearing/bush on to the shaft and into the spigot and tighten the screw.
• Finally, once the spigot is mounted to the shaft, screw the alloy knob on turning clockwise and nip up with a 10mm spanner.

Our replacement Carbon knobs are manufactured from UK-made carbon and are machined and assembled by us. They measure 45mm x 18mm.